Water Level Output View

Navigation:  Data Types > Water Levels, depths and NAPL depths >

Water Level Output View

 Previous pageReturn to chapter overviewNext page

Water Levels Table – WL1_WaterLevels_AHD

 

clip0007

The  WL1_WaterLevels_AHD data view represents water level data corrected to Above Height Datum (AHD).  The Water_Level = ReferenceElevation – Water_Depth_bTOC.

Reference Elevation is either Top of Casing (TOC from Wells table) or Elevation (from Locations table) if the TOC is not entered.

Water Levels Table – WL2_WaterDepths data view

 

clip0008

Water_Depth_bTOC

Water depth below TOC.  This is the depth of the water as measured from the Top of the Well Casing (TOC) to the surface of the water within the well.

This is the same value that is entered in the GroundWater import template

Water_Depth_bgl

This is the depth of the water as measured from ground level to the surface of the water within the well.  In WL2_WaterDepths data view is only calculated if elevation data is included in the Locations table and TOC data is included in the Wells table.